Re: [MV] spot weld drills

I like the hole cutter type:
[url]http://www.premiertools.co.uk/usrimage/cutter.jpg[/url]
You have to make a DEEP center punch to engage the spring loaded pin, then start slow and adjust
your drill, front to back, side to side, to cut even. Once you've got the circle started you can
add a drop of cutting oil then bear down on the drill, but slower is better. When you see a little
puff of rust then you are through the top sheet metal. Used properly one cutter should last for a
lot of cuts.

Regards,

Buzz



On Tue, 15 Feb 2005 10:55:36 -0800 (PST), you wrote:[color=blue]
>
>Anyone have a preference or recommendation for a spot
>weld drill? One is the hole cutter style the other is
>like a counter-sink. I have to repair my M37 fender
>and remove the reinforcement to do the repair.
>
>Thanks,
>Rick
>
>[/color]


===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>