| | |
| |||||||
| Forums | Register | Groups | Awards | Arcade | Pets | T-Bucks / T-Store | Invite Your Friends | Blogs | Mark Forums Read |
| MV List Archives of the MV Mailing List |
 |
| | LinkBack | Thread Tools |
02-21-2005, 02:50
| #1 (permalink) |
| Civilians |  Re: [MV] How to fix exhaust manifold cracks After a good run whilst everything is still hot , quickly grind as clean as is practical ,a die grinder is often the ideal tool. All equipment should be ready , speed is of the essence as the engine heat is your preheat in this application ! Then using a high nickel rod of 2mm or 2.5mm weld up , using just enough heat to run the rod smoothly ! If the crack is caused by the manifold being worn thin then welding a coverplate of steel formed to fit over the thin area will help . The same principle may also be used in brazing a patch on ! Good luck Noel ===Mil-Veh is a member-supported mailing list=== To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org> To reach a human, contact <ack@mil-veh.org> |
     |
| Trackpads Information |
| |
|
| Bookmarks |
| Thread Tools | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Re: [MV] How to fix exhaust manifold cracks | David B | MV List | 0 | 02-21-2005 02:50 |
| Re: [MV] How to fix exhaust manifold cracks | ygmir | MV List | 0 | 02-21-2005 02:50 |
| Re: [MV] How to fix exhaust manifold cracks | Bob Ternes | MV List | 0 | 02-21-2005 02:50 |
| Re: [MV] How to fix exhaust manifold cracks | Royce C Hayes | MV List | 0 | 02-21-2005 02:50 |
| [MV] How to fix exhaust manifold cracks | 42Ford GPW | MV List | 0 | 02-21-2005 02:50 |
 |  |  |
![Re: [MV] How to fix exhaust manifold cracks](http://www.trackpads.com/forum/iconimages/mv-list/re-mv-how-fix-exhaust-manifold-cracks_ltr.gif)
