Re: [MV] M35A2 wheel seals

The gasket maker I was thinking of last night is Permatex "The Right Stuff".

Jim

[color=blue]
> Which seal? Inner, Outer, keyway?
> Take a look at [url]http://208.190.133.201/axle/m35_axle_seals.html[/url]
>
> A lot of people use form-a-gaskets for various applications. I've never[/color]
used[color=blue]
> that stuff for a wheel seal, but I can say it has worked 100% the first
> time, every time, everywhere else I've used it. Blue, Orange,[/color]
Copper...maybe[color=blue]
> I've just been lucky. Still, if no one here says this is a bad idea, I'd
> give it a try myself.
>
> Wasn't there a thread here lately praising a particular modern product?[/color]
Or,[color=blue]
> did I see that somewhere else? Something, I think, in a cheeze-wiz like[/color]
can?[color=blue]
>
> CRS syndrome, sorry.
>
> Jim
>
>
>
>
>
>
> ----- Original Message -----
> From: "sandman9" <sandman9@optonline.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Thursday, September 02, 2004 9:01 PM
> Subject: [MV]
>
>[color=green]
> > Looking for NAPA # for wheel seals on a M35A2
> > John Peterson
> > MTA
> > CJMMP
> > MVPA
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to[/color][/color]
<mil-veh-digest@mil-veh.org>[color=blue][color=green]
> > To reach a human, contact <ack@mil-veh.org>[/color]
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>[/color]


===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>