![]() | ![]() | ![]() |
| |||||||
| Forums | Register | Groups | Awards | Arcade | Pets | T-Bucks / T-Store | Invite Your Friends | Blogs | Mark Forums Read |
| Automotive Discussions about civilian vehicles and parts. |
![]() |
| | LinkBack | Thread Tools |
| | #1 (permalink) |
| Civilians | Can anyone give me info on what is needed to re-charge the A/C on a 2000 Chevy Cavalier. Thank You -- Posted using the http://www.autoforumz.com interface, at author's request Articles individually checked for conformance to usenet standards Topic URL: http://www.autoforumz.com/GM-2000-Ch...ict111040.html Visit Topic URL to contact author (reg. req'd). Report abuse: http://www.autoforumz.com/eform.php?p=520892 |
|
| | #2 (permalink) |
| Civilians | kiwiusa wrote: > Can anyone give me info on what is needed to re-charge the A/C on a > 2000 Chevy Cavalier. Thank You > Are you talking top off or full recharge after opening system to do a repair ? R 134A can become dangerous if " oxygenated " *** Never use compressed air to test a R 134A system *** That's why the special ACME valves . For starters use a Pressure guage to determine if system holds pressure, if it's flat, you need serious servicing, if it's down a bit, use a can tapper to add R134A to * Low * side. The Tapper is a few bucks at any auto parts store, along with the R134A which you can buy without a licence. The pressure guage may be a bit hard to find, try a big auto parts store, or a dept. store with a big auto section. Florescent dye can be purchaced in tiny cans that connect to tapper, add to low side with compressor running, you might want to short low pressure switch [ on accumulator ] to get compressor running if system is low. For serious AC service, you need an evacuator, plan is to draw vacuum on system for at least 1/2 hour to remove air and moisture from system. Failure to do that will result in system icing up [ water vapor ] or blowing up [ oxygenated R134A ] . If you only want to keep your AC in top tune, get it evacuated and recharged by a " good " shop. Write down outside air temperature, and pressure indicated on guage. Later on, on a day that's the same temperature, check pressure with guage, add R134A until pressure is same as when car left shop. Air temp affects pressure, since I suck at math, I go with " same temp " readings. |
|
![]() |
| Bookmarks |
| Thread Tools | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Re: Chugging/Bucking Chev Cavalier | UrbanSherpa | Automotive | 0 | 09-24-2005 12:00 |
| ~~~2003 Chev Cavalier-Trans Fluid~~~~ | sanjsjenn | Automotive | 0 | 03-13-2005 00:00 |
| 98 Chev Cavalier, tension pully | Shanise25 | Automotive | 5 | 07-28-2004 09:01 |
| 98 Chev Cavalier, tension pully | Shanise25 | Automotive | 4 | 07-28-2004 00:28 |
| 2000 cavalier | bob | Automotive | 4 | 06-14-2004 20:56 |
![]() | ![]() | ![]() |